CGG Decals – Scripty Letters and Numbers
BRAND NEW! Our new range of decals are perfect for adding to your glass fusing. The design features letters and numbers in a scripty font.
Simply cut out your decal, soak in clean warm water, when the transfer uncurls remove from the water. Then slide the transfer from the backing paper and onto your glass. Squeegee the transfer to remove any water between the decal and the glass. Allow to dry for around 2 hours before firing.
The recommended firing temperate is between 745 - 760C, lower temperatures enable colours to stay bright. It is recommended you full fuse your glass and then apply the decals and re-fire. Please note that when firing to higher temperatures colours will fade.
Once kiln fired these decals are permanent and will not scratch or rub off. For best results use opaque glass. Please note that these glass decals have a flux overcoat which will leave a faint line where you cut the decal.
Included are two sheets, sheet size 210mm x 297mm sheet 1 contains uppercase letters and sheet 2 contains lower case letters, both sheets contain numbers also.
Approx decal sizes - height of uppercase letters 18mm, height of lowercase letters 14mm, height of numbers 14mm.